 |
 |
 |
|
Price listed is subject to discount
Price is for 1 Bookmark Mold
Available in 3 sizes
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Additonal Information
- Material: Silicone. Silicone Is Flexible, Resistant To Tearing, Durable In Use, Easy To Use And Clean
- Easy use: Each mold has a pin, so it is easy to make holes in the top of bookmark without punching. It is easy to use with string or chain.
- Special design: The small cylinder used to make the hole, the height is higher than the edge of the mold, ensuring that the hole of the bookmark is not covered by the resin
- High quality: Help You Make Perfect bookmark, Guaranteed to Get Straight and Smooth Edges
- Molds Measure:
- Size #1 - 5.11" x 1.18" (13cm x 3cm)
- Size #2 - 5.11" x 1.37" (13cm x 3.5cm)
- Size #3 - 5.51" x .98" (14cm x 2.5cm)
- What you can use with this mold: Silicone molds are suitable for epoxy resins and casting resins (Such as Castin Craft Easycast resin and fastcast Resin), but not for coating resins (Such as Envirotex). Can also be used with UV resin and Liquid Bakeable Clays (Such as Liquid Sculpey and Liquid Kato Polyclay).
- For use with UV resins: It is recommended to cure the resin for 120 seconds, then remove the piece from the mold carefully and cure the other side that had been facing the mold for 120 seconds to make sure the piece is fully cured.
|
|
|
|
|
|
|